![]() |
![]() |
|
|||||||
| Register | Members List | Timeslips | Calendar | Sponsors | Becoming a Sponsor | Mark Forums Read | Auto Escrow | Auto Loans | Insurance |
![]() |
|
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
|
black smoke then truck dies cranks but wont start
Today my 2006 6.0 shut down after a series of hard uphill pulls while pulling a 38' fifth wheel camper. Started blowing black smoke like if I had a programmer installed (I dont!) While pulling hard uphill it startebecoming sluggish and losing power, and blowing a good bit of black smoke, once I started down hill I got off the accelerator and it died. I coasted all the way down into a service station.
Truck spins super fast but no fire!!!! I removed fuel bowl cap, turned key, and we have fuel filling up. I removed EGR Valve and checked to see if stuck open. Its not, cleaned it and reinstalled Shot a little starting fluid into intake. No start Oil level. Good Coolant. Good Also did long crank, oil pressure gauge jumps to mid range. I've been reading up, IS IT POSSIBLE EMERGENCY FUEL SHUT OFF SWITCH FLIPPED? What is next step? Remember hard uphill pulls, black smoke, down hill truck dies!!! |
| Sponsored Links | |
Advertisement |
|
|
#2
|
||||
|
||||
|
Re: black smoke then truck dies cranks but wont start
Where is the shut off switch located so I could check it?
Thanks |
|
#3
|
|||
|
|||
|
Re: black smoke then truck dies cranks but wont start
Right front under the plastic kick panel on right side, dont think that's your problem but the best of luck.
|
|
#4
|
||||
|
||||
|
Re: black smoke then truck dies cranks but wont start
Ok thanks im going check.
Anyone else??????? ok NOT the emergency FUEL SHUT OFF SWITCH |
|
#5
|
||||
|
||||
|
Re: black smoke then truck dies cranks but wont start
Turbo would explain the smoke, but not dying...
__________________
"Shamoo" 2002 F250 7.3 E.C.L.B. e99 block. 18"KR Wheels, Rosewood 238/100's,BTS 4R100,Gearheads tunes,6637, 4 inch down, 5 back, 7” tip. DI headers, I.H. bellowed up pipes, Garrett 38r 1.0,CCV Mod |
|
#6
|
|||
|
|||
|
Re: black smoke then truck dies cranks but wont start
do u hav anyway to monitor icp? u could try starting with unplugged icp sensor. u need some gauges to diagnose problems.
|
|
#7
|
||||
|
||||
|
Re: black smoke then truck dies cranks but wont start
Kinda late to repost the actual fix to this problem.
Problem was oil line with quick connect on back of engine, it had popped off. Replaced oil line with no quick connect, truck runs great again. Thanks for all who tried to help. |
![]() |
(View-All)
Members who have read this thread : 37
|
|
| 04fivefour, 6.0_psd, 6.9to6.0, 99whitePSD, abbottfarms, ajfetterman, bismic1, bode26, brute_mt, ghohouston, gwskulls, halbig7, hudsonb, jawsfx4, Jeremy, joe_r_dog, Krisco, Low Key, Michael5126, MrBill1, mudworld, myloyambag, newpowertroker, NH OIL BURNER, orchard6, pastorsid, Powerstroke2006, prstrk025, Realdealoo8, shadow6.0, smokinford07, Softballguru, Sparkymichigan, spruill242, tonka350, treetechsixOH, wargle |
| Thread Tools | |
| Display Modes | |
|
|