Ford Power Stroke Nation banner

Bone Stock 7.3L Dyno Runs

22K views 13 replies 10 participants last post by  Thomas A 
#1 ·
I wanted to get some baselines pulls on my truck (early 99) prior to doing some mods, so I put it on the rollers this morning to see where it is at.

Drum roll....... 165rwhp 450rwtq. :ford:

100% stock down to the paper filter in the stock air box. 153K miles through an automatic transmission. Does that sound about right?

Thomas
 
#3 ·
It was on a loaded dyno (Dyno Dynamics) so we spooled the turbo for 1.5 seconds prior to releasing the load. That might have helped out a bit??

I don't have the printout yet as their printer died. I am hoping they will email me one soon.

Thomas
 
#5 ·
Torque should always be quite abit higher when at lower hp levels.Good run!
 
#8 ·
Lol within the 1st month of having my early 99 it had gauges, clutch, intake, exhaust, and chip:evil 3 years later some bigger things are happening. Can't wait to get it running again.
 
#10 ·
Back in 03 when my truck was 3 months old I dynoed it stock and I was at 190 and 500. That was down in effingham IL at schieds with the MOB midwest oil burners
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top