Had an oil leak from turbo pedestal.Replaced 4 o'rings. Engine started and runs OK,except when I push it. There is almost no boost 0-2 #(on the boost gauge)and a lot of blackish,brown smoke. What did I do wrong?It all went back together OK no extra parts.Please help,I'm open to all sugestions
Thanks
I took off the IC tubes,clear.I flushed water thru the intercooler,it flowed good,then blew out with hot pipe connected and cold pipe disconnected at intercooler started engine to blow out excess water. If a rag is in the IC,how can I get it out?
Thanks for replying
I went over the entire system,rechecking all connectors,clamps,but I did not replace the large o'ring,it seemed OK,I don't think it could create my problem.My first inclination,was,that I left a rag in the IC pipe.That is why I took it all apart.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Power Stroke Nation
2.5M posts
107.5K members
Since 2007
A forum community dedicated to Ford Power Stroke owners and enthusiasts. Come join the discussion about diesel performance, modifications, EGR deletes, troubleshooting, lift kits, tires, wheels, maintenance, and more!