more issues

alright so dustin (MN_MountainMan) came out to day and we hooked up AE. got codes for ALL injectors except #8. swapped to my other idm and got codes for ALL on the right bank only. all off buzz test. had a p1661 (i think it was) and did some research and seen one guy had it and it was caused by having oil in the ICP plug. so i checked my ICP and there was oil in the plug. charged truck and tried starting and wouldnt start. checked hpop level after final try and it was about half full but there are white particles floating in the oil. almost look like styrofoam particles??? never seen that before. any ideas on that one? no loss of coolant and no loss/gain of oil on dipstick. even if i CAN get this thing to start its only going to be to get it in my garage to pull the motor and tear it down. i can get all the codes tomorrow and post em. im already in pjs and not going back out in the cold to go get em!

suck some of it out and see what it is low on oil in res sounds like 1 drain back issue or 2 bad injector o-rings.

i know the hpop res is low from cranking so much without it starting

when you are cranking it should be filling up from the LPOP.
soulnd like injecto o-rings or you are haveing the bleed down issue the 94-95 are known to have read up on it .I think there is a test procedure for it.inthe fourm.