ploughboy
12-26-2010, 10:58 PM
Today while driving I heard an odd noise under hood, also lost power steering and brake, at the time the belt was intact, but later belt shredded. the truck was still running but the belt was not turning. 1997 f350 PS
Mudbrother
12-26-2010, 11:18 PM
Check the belt tensioner. It may have seized up.
madpogue
12-27-2010, 02:39 AM
Could be anything driven off the belt; tensioner, idler, p/s pump, vac pump, A/C compressor, alternator, water pump....
blackbetty13
12-27-2010, 02:49 AM
check all pullys very well. i went out got a new belt then i was feeling the pullys and the bearings in pullys were litterally gone.
salprofish
12-27-2010, 03:06 AM
Today while driving I heard an odd noise under hood, also lost power steering and brake, at the time the belt was intact, but later belt shredded. the truck was still running but the belt was not turning. 1997 f350 PS
losing power steering going down the road is not fun!
PowerstrokeR00
12-27-2010, 03:21 AM
losing power steering going down the road is not fun!
Especially while in a turn on a highway:eek::eek::eek:
BigRed97
12-27-2010, 01:14 PM
i'd rather lose it goin down the highway than in a parking lot!!!!
check the tensioner, real common issue with our trucks
goodstktbo
12-27-2010, 01:39 PM
i'd rather lose it goin down the highway than in a parking lot!!!!
check the tensioner, real common issue with our trucks
:whs: i had to replace both of mine.
whytry
12-27-2010, 01:40 PM
i'd rather lose it goin down the highway than in a parking lot!!!!
check the tensioner, real common issue with our trucks
Never knew that can you tell if it is going out? or just it just happen whenever it feels like it?
blageurt
12-27-2010, 04:36 PM
Usually if you look at the belt it starts to fray on one side...you could hear some squeaking / abnormal noise too ...also the belt will ride up on one side
Cratos
12-27-2010, 06:32 PM
BEARING # IS 6203 FOR YOUR IDLERS
SDS97_7.3
12-27-2010, 06:47 PM
same thing happened to me 3 times, all the vacuum pump but only had the belt go the last time cause the shaft for the pulley bent inside the vacuum pump