Changed feed pump now it wont run!!

I changed my feed pump and resealed the fuel bowl with a seal kit cause i had a leak. got everything back together and truck ran noraml i let it run for couple mins and shut it off to check for leaks. restarted it and it idled for couple mins and begun to idel rough then it died. Now it wont restart and I belive I have one of my batteries going bad. So with battery chargers on it all it does is crank and smoke . I can't get it to take off. I figure its full of air so how do i get it bled out.

The air should bleed out on its own as the system is a flow through the head design. If the batteries are low the truck may not start. I would let the batteries fully charge as step one.

Tom

What Tom said, Need to have a good charge on them batts. Engine will have to spin at least 750 rpms to start and run.

Well I let it charge overnight. Tried to start this morning its just not cranking fast enough. The batts are junk so I gonna go get a new set after college today.

Well I let it charge overnight. Tried to start this morning its just not cranking fast enough. The batts are junk so I gonna go get a new set after college today.

Its proably from your K&N filter allowing to much dirt into your engine and it fragged everything so you have no compression. But serioulsy, might want to check about getting a different air filter. Also welcome to PSN!!

I got it to run finally. New batts and bled the air out of the rail ( two plugs one on each head you back out couple turns 1/4in. pipe plug.